AM194452_06_V.pdf October 22, 2001 9
Setting Up
Check the connections
Check all connections from the receiver to the Powered Acoustimass module and from the
module to the cube arrays (Figure 6). Make sure all cube arrays are connected to the proper
terminals according to their position in your room. Check that all wires are connected in
phase (+ to + and – to –). Incorrect wiring can result in a total loss of module output. Correct
wiring problems before you plug your receiver in and turn it on.
Figure 6
Completed connections
Plug in the Powered Acoustimass Module
When you have checked all connections, plug in the power cord of the Powered Acousti-
mass module. Be sure to turn the power switch on (Figure 7). It is not necessary to turn the
module off after each use. The speaker system turns on and off automatically as it receives a
signal from the receiver. Turn the system off at the receiver.
Figure 7
Turn on the Powered Acousti-
mass module
SURROUND SPEAKERS
R CENTER
FRONT SPEAKERS
R
L
LREAR
FRONT SPEAKE
R
3+ RIGHT +3
LFE/SUBWOOFER
OUT