AM195438_03_V.pdf November 21, 2001 11
Setting Up
2. Use the twin cable assemblies (with two connectors at each end) that are supplied with the
equalizer. Use one connector for the right (R) channel connections and the other connector
for the left (L) channel connections.
3. Connect the amplifier INPUT of the Bose
®
901
®
active equalizer to the PRE AMP OUT jacks
of the receiver or amplifier. Connect right channel to right channel and left to left.
4. Connect the amplifier OUTPUT of the active equalizer to the MAIN AMP IN jacks on the
receiver or amplifier. Connect right channel to right channel and left to left.
5. Plug the power cord of the 901 active equalizer into one of the switched outlets on the
receiver so that it will be powered when the receiver is switched on.
Note:
This connection method does not allow you to connect a tape deck directly to the active
equalizer. Connect it to the receiver instead.
Check to see that the 901 speakers are connected to the receiver MAIN or FRONT speaker
jacks. In this way the 901 active equalizer signals will reach only the 901 speakers – the front
channels of your home theater – and not any non-901 speakers used as center and surround
channels.
Call Bose Corporation for assistance with the connection of additional speakers or signal
processing equipment. Refer to the address information inside the back cover of this guide.
A free booklet is available (USA only): Guide to Optional System Connections for Bose 901
Direct/Reflecting
®
Speaker Systems. Ask for part number 149393.
Figure 7
Home theater receiver
connections