Filter
Top Products
System Setup
16 - English
H. Connect the speaker cable to the type of speaker you have.
For Jewel Cube
®
speakers:
Insert the plug into the speaker connector.
For Direct/Reflecting
®
and
Virtually Invisible
®
single
cube speakers:
Press the button and insert the wires. Connect
the red-collared wire to the red connector.
Connect the other wire to the black connector.
Notes:
• The rear speaker cables for Direct/Reflecting
®
and Virtually Invisible
®
single
cube speakers are webbed together. You can pull them apart as needed.
• Put the Acoustimass
®
module in its final position:
– Upright (BEST) or on either side (ALTERNATE).
– With the front opening facing into the room.
– At least 18 in (45 cm) from any TV to avoid magnetic interference with the TV
image. Move it farther away if you still notice interference.
CAUTION:
• Do not put electronic media, such as video or audio tapes, on or next
to the Acoustimass
®
module for long periods of time. The magnetic field
surrounding the module may erase some or all of the recorded material.
• DO NOT BLOCK the ventilation openings on the module. This can cause it
to overheat.
I. Congratulations! At this point you have set up the control console, the
Acoustimass
®
module, and the speakers. You are now ready to turn on
your system and enter the interactive phase of the setup process using
the UNIFY
®
intelligent integration system.
Continue with Box
4
on the next page.
Ventilation
openings