Bose 510 Home Theater System User Manual


 
System Setup
16 - English
H. Connect the speaker cable to the type of speaker you have.
For Jewel Cube
®
speakers:
Insert the plug into the speaker connector.
For Direct/Reflecting
®
and
Virtually Invisible
®
single
cube speakers:
Press the button and insert the wires. Connect
the red-collared wire to the red connector.
Connect the other wire to the black connector.
Notes:
• The rear speaker cables for Direct/Reflecting
®
and Virtually Invisible
®
single
cube speakers are webbed together. You can pull them apart as needed.
• Put the Acoustimass
®
module in its final position:
Upright (BEST) or on either side (ALTERNATE).
With the front opening facing into the room.
At least 18 in (45 cm) from any TV to avoid magnetic interference with the TV
image. Move it farther away if you still notice interference.
CAUTION:
• Do not put electronic media, such as video or audio tapes, on or next
to the Acoustimass
®
module for long periods of time. The magnetic field
surrounding the module may erase some or all of the recorded material.
• DO NOT BLOCK the ventilation openings on the module. This can cause it
to overheat.
I. Congratulations! At this point you have set up the control console, the
Acoustimass
®
module, and the speakers. You are now ready to turn on
your system and enter the interactive phase of the setup process using
the UNIFY
®
intelligent integration system.
Continue with Box
4
on the next page.
Ventilation
openings