Filter
Top Products
AM250811_04_V.pdf October 30, 2001 11
Making the connections (cont.)
Putting the speakers in the final location
Loosen the knobs on each speaker to rotate the speakers into the desired position. Then,
tighten the knobs to secure the speaker in its final position (Figures 18A and 18B).
Figures 18A and 18B
Putting the speaker in the final
position
A. Exterior of the house
B. Deck railing or table
A.
B.
Installing Your 251
TM
Speakers
Attaching the rubber feet
If you do not plan to use the supplied brackets to mount your 251 environmental speakers,
you can place them on a sturdy, level surface. They should be standing in the vertical posi-
tion. Be sure to attach the rubber feet before using your speakers. For proper balance be sure
to place the feet in the position shown in Figure 19.
Figure 19
Attaching the rubber feet
Rotating the Bose logo
Mounting the speakers on a deck railing or table will require you to rotate the Bose logo.
Using your fingers, gently lift the logo, taking care not to detach it from the speaker, about
1
⁄
4
inch (.24 cm) and turn it 180º.
Figure 20
Rotating the Bose logo