Filter
Top Products
Antenna Connection
FM Dipole Antenna
The indoor dipole antenna provided should be adequate for normal FM
reception.
1. Connect the antenna leads to the two terminals marked 300 Ohms
(FM and GND).
2. Position the antenna for the best reception. Tack it to a wall or baseboard
if possible.
For reception when the DST1 is installed in a rack, an external antenna
installed in accordance with National Electric Codes may be required.
FM Coaxial cable connector
For applications using coaxial cable, an FM 75-Ohm coaxial cable connector
is provided.
AM Loop Antenna
The DST1 is provided with an external AM antenna for AM reception.
1. Carefully pull the antenna lead from the holding notch in the antenna
and unwind the lead from the loop.
2. Connect the antenna leads to the terminals marked AM LOOP
(AM and GND).
3. Snap the antenna into the base to form a free-standing unit.
4. Position the antenna for best reception. If desired, the antenna may be
permanently mounted using screws through the two holes in the base.
Audio Connections
An audio patch cable is provided to make audio connections.
1. Connect the two RCA plugs from one end of the cable to the R and L
STEREO terminals on the DST1. (Note: For mono applications, connect
one end of cable to the MONO terminal.)
2. Connect the other end of the cable to a line-level input (Hi-Z) of an audio
pre-amplifier.
Operation
Power
Press the front panel POWER button to turn on the DST1.
Turn the rear-mounted VOLUME control counterclockwise to attenuate
audio output. Turn fully clockwise for full output.
7