Filter
Top Products
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel.201-934-8500, Fax: 201-934-9832, www.bogen.com
1) Cut a rectangular hole 4-
1
/16" wide and 3-
3
/4" high in the sheetrock
where the attenuator is to be mounted.
2) Pull approximately 12" of the amplifier and speaker cables
through the hole.
3) Push each of the separate cables through the electrical box entry
holes and pull about 6" of cable out of the front of the box.
4) Rotate the two screw-mounted tabs down against the box and
slide the electrical box into the opening until it stops against the
wall.
5) Begin to tighten both of the electrical box screws until the box is
held firmly in the wall. Rotate the clips on the screws into place
and clamp the box against the wall.
6) Make all the necessary electrical connections as shown in the
“Attenuator Wiring” section on the front of this sheet.
7) Remove the protective plastic film covering from the attenuator
face plate.
8) Mount the attenuator to the electrical box using the 4 screws
provided. Using a Phillips head screwdriver, screw the attenuator
into place.
Screw-mounted tab
(down)
Rotated screw-
mounted tab
Entry holes
Attenuator Installation
The AT10A and AT35A are warranted to be free from defects in material or
workmanship for two (2) years from the date of sale to the original purchas-
er. Any part of the product covered by this warranty that, with normal instal-
lation and use, becomes defective will be repaired or replaced by Bogen, at
our option, provided the product is shipped insured and prepaid to: Bogen
Factory Service Department, 50 Spring Street, Ramsey, NJ 07446, USA.
The product will be returned to you freight prepaid. This warranty does not
extend to any of our products that have been subjected to abuse, misuse,
improper storage, neglect, accident, improper installation or have been
modified or repaired or altered in any manner whatsoever, or where the seri-
al number or date code has been removed or defaced.
THE FOREGOING LIMITED WARRANTY IS BOGEN'S SOLE AND
EXCLUSIVE WARRANTY AND THE PURCHASER'S SOLE AND EXCLU-
SIVE REMEDY. BOGEN MAKES NO OTHER WARRANTIES OF ANY
KIND, EITHER EXPRESS OR IMPLIED, AND ALL IMPLIED WAR-
RANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO THE MAX-
IMUM EXTENT ALLOWABLE BY LAW. Bogen's liability arising out of the
manufacture, sale or supplying of products or their use or disposition,
whether based upon warranty, contract, tort or otherwise, shall be limited to
the price of the product. In no event shall Bogen be liable for special, inci-
dental or consequential damages (including, but not limited to, loss of prof-
its, loss of data or loss of use damages) arising out of the manufacture, sale
or supplying of products, even if Bogen has been advised of the possibility
of such damages or losses. Some States do not allow the exclusion or lim-
itation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights which vary from State to State.
Products that are out of warranty will also be repaired by the Bogen Factory
Service Department -- same address as above or call 201-934-8500. The
parts and labor involved in these repairs are warranted for 90 days when
repaired by the Bogen Factory Service Department. All shipping charges in
addition to parts and labor charges will be at the owner's expense. All
returns require a Return Authorization number.
08/10/2004
Limited Warranty