Filter
Top Products
5
SECTION 3: Pairing Earpiece to Your Phone
Before you use the earpiece for the first time, you must pair
the earpiece with your mobile phone. For Hands Free mode
pairing instructions, see below.
To pair in Headset mode:
1.Activate the Bluetooth
®
function on your phone or other
device. Please refer to the owner‘s manual of your
phone for instructions on activating the Bluetooth
®
pairing function.
2.To pair the earpiece, press the pairing button once until
the LED indicator light on the earpiece flashes an
alternating green and amber. Make sure the earpiece
and phone are close to each other.
3.Follow the Bluetooth
®
pairing/set-up instructions and
screen prompts on your phone to pair it with the
earpiece. Please refer to your phone‘s owners manual
or go to www
.fellowes.com/bluetooth for specific pairing
instructions.
4.When prompted, enter the earpiece password: 0000. If
desired, password may be changed. Please refer to the
owner‘s manual of your phone for instructions.
5.If pairing is successful, the LED indicator light will show
solid green for 4 seconds and then switch off.
To pair in Hands Free mode: Follow steps 1 and 2, and
then press the pairing button again. The LED indicator light
will flash alternately amber and green at a faster cycle.
Then continue with steps 3 to 5.
PLEASE NOTE: Most Bluetooth
®
phones will pair with the
earpiece in Headset mode, but some will also pair in Hands
Free mode which provides additional functionality (see your
phone‘s owners manual for more information). Pairing in
Hands Free mode automatically pairs the headset in
Headset mode as well.
If pairing does not work, wait 90 seconds, reset your phone
or device to the beginning of the Bluetooth
®
pairing process,
and repeat steps 1-5. Once pairing is complete, your
earpiece will work with your cell phone any time both units
are powered on and in close proximity to each other.
Resetting the Earpiece
When pairing the earpiece to a new Bluetooth
®
device, the
earpiece resets itself to its default settings. This clears all
current pairings and returns all functions (e.g. volume) to
the original setting.
SECTION 4: General Operation
To turn the earpiece on:
Flip the on/off switch to the
on (l) position. The LED
indicator light will flash
green twice and then stay
off. You will hear short low,
medium and high tones in
quick succession.
To turn the earpiece off:
Flip the on/off switch to the
off (0) position. The unit will
immediately turn off without
any additional signal.
Figure 6
BlueSport_1Manual 6 language.qx 12/12/03 11.28 AM Page 5