Filter
Top Products
– 8 –
SYSTEM CONFIGURATION #1
SYSTEM CONFIGURATION #2
5 Channel Combo (2ch HP + 3ch passive Multi-Mode)
The multi-mode system is a “poor-man’s” satellite/subwoofer
system. This amplifier is able to drive speakers in stereo
mode and at the same time drive low frequencies to a
dedicated subwoofer speaker. By inserting inductors (coils) and capacitors, the result is an inexpensive solution to
generating a ‘5' channel system with a 4 channel amplifier.
Using passive components (coils and capacitors) the installation is simple and performs adequately for most listeners.
Such a system will not perform as well as an “active” system because the slow attenuation (roll-off) of the frequency
response resulting in a moderate amount of over-lapping of the sound spectrum between the satellites and subwoofers.
It is important to remember that although surprisingly pleasant performance is achieved, this is a compromise system
and will NOT perform as well as a dedicated 5 channel system with electronic crossovers.
Full-Range
High-Pass
Full-Range
High-Pass
Subwoofer
4 Channel (Full-Range,HP)
For many listeners, they need only slightly higher system loudness and/or music dynamic range without the amplifier
going into distortion. By simply adding additional power to the speakers this can be achieved in many installations.
BUT, the speakers must be able to handle this additional power without damage.
Such installations are most common with listeners who only need systems that can play moderately loud. Also, this
consumer is often a person who simply cannot, or will not, accept additional amplifiers or speakers in the vehicle. Such
systems will not be able to perform as well as audio systems with additional speakers and amps, but this is often an
accepted trade-off for this consumers.
Full-Range
Full-Range
Full-Range
Full-Range
www.midwestelectronics.com