Filter
Top Products
Page 12
The AV2500 series II may operate with 2 channels bridged to drive a high impedance
speaker. To use, place the source group jumper for both channels on the ‘L BUS’
jumper terminal. Place the volume group jumper for both channels on the ‘NO VOL’
jumper terminal. Place the invert jumper module on the ‘-L’ terminal. One of the
bridged channels be either channel 4 OR 5.
Finally, connect the speakers (+) to channel 3's (+) terminal and the speakers (-) to
channel 4's (+) terminal. Input your source signal into the left channel input (
).