Belkin F8E477 Headphones User Manual


 
User Interface and General Operation:
LED chart
Dark - Power is off (not connected to iPod)
Solid Green (center LED) - Connected to the iPod
(2–3 second recognition period)
Solid Red (center LED) - Power is on but battery
power is low
Running Green - Transfer button has been pressed and
stays on throughout transfer process
Solid Green (all 3 LEDs) - Transfer or verification
complete
Running Amber – Verification process
Flashing Red (outside LEDs) - Incompatible source
device,unable to transfer from camera (5–10 second
recognition period)
Flashing Red (center LED) - Cannot write to iPod
(e.g.disk full)
NOTE:After a file transfer is complete,disconnect the Unit from both the
camera and the iPod.Reconnect the iPod to the Unit to reestablish the
“ready”state.The Unit is now ready to connect to a camera for another
file transfer.
NOTE:The Unit will perform transfers when battery status is low,however,
we strongly suggest that you verify file transfers performed in this
condition.Should the transfer fail,insert new batteries and repeat the
transfer procedure.
Transferring photos using iPhoto™:
Connect the iPod to your computer.If you are using a Macintosh®
computer,iPhoto will automatically detect photos on the iPod and
iPhoto will open.
Setup Instructions
1. Power on the iPod.
2. Connect the Digital Camera Link (the Unit) to the iPod.The Unit
will turn on automatically.After a few seconds,the LED will turn
green to indicate proper connection.See below LED chart for
further LED interpretation.
3. Connect your digital camera to the Unit.
4. Press the button once on the Unit to initiate file archive.
5. After transfer is complete* (see LED chart below),the user has
three options:
a) Press the button again to begin the data verification process;or
b) Disconnect the Unit from the iPod;or
c) Manually check the iPod for complete file transfer.Once the
“OK to disconnect”or the “Main Menu”screen appears after
transfer is complete,select “Extras > Photo Import”and select
the roll number for verification.Photos are listed on the iPod
by roll number in the “Photo Import”folder.
6. The Unit will power off immediately after disconnecting the Unit
from the iPod.
*You CANNOT view the photos on the iPod.
NOTE:Disconnect the Unit when not in use to preserve battery life.Belkin
recommends use of high-quality alkaline batteries.Battery life depends
greatly on the type of media being used and the type of battery being used;
however,a single set of high-quality alkaline batteries should allow transfer
of 24 or more typical 128MB CompactFlash® cards (3GB or more of data).
NOTE:Do not disconnect the Unit from the iPod while files are being
transferred.The message “Do Not Disconnect”will appear on your iPod
during the archive and data verification process.It is safe to disconnect
your Unit from the iPod when the message “OK to Disconnect”or “Main
Menu”is displayed on your iPod or after the media transfer is complete.
Transferring photos using the iPod as a disk drive:
Connect the iPod to your computer.Through the My Computer
menu,double-click the removable drive that represents the iPod.
Double-click on the DCIM folder.Each folder (XXXAPPLE) represents a
specific import.Double-click on a folder to view the images.You can
also transfer images to your computer by opening this folder and
dragging them to the desktop.
NOTE: While the iPod is connected to your computer,you can erase the
images from the DCIM folder on your computer and the images will be
deleted from the iPod once disconnected.
Folder Structure on iPod
The images are stored as “Rolls”in the DCIM directory.Each “Roll”is
indicated by a folder containing the individual photos.
iPod
DCIM (“Digital Camera Images”folder)
—— 001APPLE (Photo Roll folder:each roll is in a separate folder,—
—— 001APPLE "001APPLE", "002APPLE",etc.)
——— xxxxxxxx.jpg (individual photo files)
To erase photos from the iPod:
1. Disconnect the Unit from the iPod.
2. Select “Extras > Photo Import”and select the roll number you
would like to delete.Then select “Delete Roll > Delete”.
Specifications
Archives up to 2,000 files in one session.Copies ALL camera file
types (e.g.JPEGs,AVIs,MPGs,etc.)
Transfers over USB at 0.8 to 1Mbps,depending on the maximum
speed capacity of the attached USB device (camera)
Supports both FAT32 and HPFS iPod formats
Compatibility Chart
Compatible with Apple® 3G iPod players—10,15,20,30,and
40GB models.
Digital cameras supported will be those using either the PIMA 15740
PTP protocol or the FAT 12/16/32 mass storage format.These devices
must also use either Bulk Only or Control/Bulk or
Control/Bulk/Interrupt USB protocols.
Supported Cameras
Manufacturer Camera Name
Canon® IXUS V3
Canon S45
Fuji® FinePix F401
Jenoptik JD C2.1 LCD
Kodak® DX3500
Kodak DX4900
Konica® KD100
Minolta® F200
Nikon® CoolPix E775
Nikon CoolPix 5700
Nikon CoolPix 775
Olympus® Camedia C-2
Olympus C350
Olympus Camedia C-750
Packard Bell® DSC200
Panasonic Lumix™ LC33
Rico Caplio RR230
Sony® Cyber-shot® DSC-P2
Sony Cyber-shot DSC-P72
Sony Cyber-shot DSC-P71
Sony Cyber-shot U30
NOTE: Above list is for reference only.Other cameras may be added.This
list does not represent the entire range of compatible cameras.
The Unit is not recommended for use with a media reader,which
would cause significant battery drain.Does not work with
Microdrive-type media.