Filter
Top Products
page 6© 2002-2004 bel canto design, Ltd. eVo2i User’s Guide rev081104
SOFT AND FULL
MUTE FUNCTIONS
PRESS ENTER AND HOLD TO
ACCESS SETUP MENU*
VOLUME CONTROL
AND UP/DOWN KEYS*
TAPE INPUT SELECT*
MUTES OUTPUT, DISABLES DISPLAY
AND CONTROLS
MAIN INPUT SELECT*
*ALSO USED FOR NAVIGATING THE SETUP MENU
Balance Right: (available from the
remote only)
Shifts balance right in 0.5dB steps. It is
also used to scroll right in the setup
menu.
MUTE:
The eVo2i starts up in Soft Mute. This
level is 20dB below the displayed vol-
ume level. When MUTE is first pressed it
goes to the Soft state, pressing MUTE
again within 3 seconds will fully MUTE
the outputs.
ENTER:
This control button is pressed and held
on the front panel or pressed 7 times on
the remote to enter into the menu setting
functions described below. It is also used
to enter into specific modes within the
menu system.
MAIN:
Cycles through the main inputs. It is also
used to scroll to the left in the setup
menu.
LOOP: (available from the remote only)
This is used to cycle through the inputs.
INPUT:
On the remote the Numbered Buttons (1-
5) allow you to select between the active
inputs. From the remote, you can cycle
through inputs using the LOOP button.
From the front panel, you can cycle
through inputs by pressing the MAIN
button. When switching between inputs,
the eVo2i will quickly ramp down the
volume, switch inputs, then quickly ramp
back up to the programmed volume set-
ting.