Filter
Top Products
Display: Toggles through several display options:
1. Standard: displays selected Input on the left
and Volume on the right.
2. Sample Rate: displays selected sample rate.
Regardless of the display mode you are in, this
display will appear whenever your source
changes sample rate:
3. Product Name
4. Software Version see page 6 for image
5. Display Off. Using the remote or using the
control knob will turn the display back on for 3
seconds.
Mute: When in variable output mode this will switch
the analog outputs from Soft to Hard Mute and Un-
muted modes. Soft Mute is indicated by the word
SOFT overwritten on the volume level display. Hard
mute over-writes the level display with MUTE. The
Mute function will Punch Through to any Bel Canto
unit set in Variable Output mode.
Number Buttons: Use for direct input selection.
1: AES 2: SPDIF1 3: SPDIF2 4: TOSLINK
5: High Speed ST Fiber 6. Analog Input
Bal L/ Bal R: Shift the balance up to 6.0 dB towards
either channel in increments of 0.5 dB. If the
balance is activated, a carrot will appear on the
display. It will point towards the direction in which
the balance is shifted
Phase: Invert the phase. If enabled, you will see a
dash to the left of the volume.
When both Balance and Phase shift are in effect,
you will see this: