Filter
Top Products
8
OPERATION
®
BACK button will not step you back, simply hit EXIT and start again.
Where an additional "ENTER" press is required to write the selection to memory, the
screen will prompt you with "[ENTER] to Confirm".
The LED display also offers some navigation help. Left or right arrows on the top line
indicate the BACK/NEXT buttons will step to other choices.
7.2 SUBMENUS
7.2.1.1 Crossover Submenu
This menu selects the type of crossover and is the primary submenu to create,
recall, delete, and name a program configuration.
Press MENU and ENTER to access this submenu. Then use the BACK, NEXT and
ENTER buttons to adjust the Xover Submenu. Included submenus follow:
7.2.1.2 Load a Xover:
This will load a configuration that has previously been saved into the memory
of the unit. Until you have saved other programs into the unit, nothing will be
available to load. Only the previously selected program will display.
7.2.1.3 Design a Xover;
Use this mode to select from the ten different types of X-OVER and distribution
configurations.
7.2.1.4 Store a Xover:
Store all the configuration settings of a X-OVER. The DS48 will store up to 30
program configurations in user memory locations. (An unlimited number can be
stored on a PC or other PC accessible memory.) Each of the 30 programs can
have a name containing up to 16 letters and numbers. If the program name is
not edited, it is stored under the corresponding mode name, such "2 x 4 WAY
XOVER".
7.2.1.5 Erase a Xover:
This will delete a user-created configuration.
7.3 Security Submenu
This menu allows you lockout various combinations of any or all front panel programming
functions. A password with up to four-characters is created by the primary user and
entered using the FREQ knob to select the character and the BACK/NEXT buttons to move
the cursor to the four available spaces. To unlock the system, the password must be re-
entered.