Filter
Top Products
30 AMP X 2 MAX
+12V GND
TURN
ON
REAR
FRONT
LEFT
RIGHT
2
2
CHIL
BRIDGED
MIN
4
30 AMP X 2 MAX
+12V GND
TURN
ON
REAR
FRONT
LEFT
RIGHT
2
2
CHIL
BRIDGED
MIN
4
9
ENGLISH
Make the speaker connections using speaker wire that is at least 16 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential for
strong bass response. When connecting, make sure that positive (+) from the amplifier is
connected to the positive (+) of the speaker, and the same for negative (-).
SPEAKER CONNECTIONS
4 Ohm
(2 Ohm Minimum)
4 Ohm
(2 Ohm Minimum)
4 Ohm
(2 Ohm Minimum)
4 Ohm
(2 Ohm Minimum)
SPEAKER CONNECTIONS (BRIDGED)
The MGA amplifiers are capable of being bridged in a mono configuration. This feature
allows you the flexibility of using the amplifier to drive a ** subwoofer or a center channel.
In this configuration the amplifier sums the right and left channel to deliver one channel
(mono) output.
**CAUTION! In the bridged mode, the amplifier must see the recommended minimum
impedance or higher. Any lower than the recommended minimum impedance will cause the
amplifier to overheat and possibly cause permanent damage to the amplifier!
8 Ohm
(4 Ohm Minimum)
8 Ohm
(4 Ohm Minimum)