Banner MA3 Stereo Amplifier User Manual


 
Models SP100C and CCF are ideally suited to applications where depth of eld
is critical. The emitter and receiver are both directed at a point 0.1 inch (2,5mm)
ahead of the front surface. An aperture is included which, when attached, nar-
rows the depth of eld (see curves, below). This is particularly useful when it
is necessary to detect an object while ignoring another object or a surface just a
fraction of an inch farther away. The high excess gain at the focus allows detec-
tion of objects of low reectivity. The SP100C and CCF differ only in housing
style. Model SP100C is for general application. Model SP100CCF is used where
a narrow prole is important for mounting.
SP100E &
SP100R
Range: 8 inches (20cm)
Beam: infrared, 880nm
Effective beam: .05 inch
(1,3mm diameter)
Cable (all 6-foot lengths):
SP100E: 2-wire ribbon cable
(white, green).
SP100R: 3-wire ribbon cable
(red, black, yellow).
SP100D, DB, C, CCF: 5-wire
ribbon cable (white, green, red,
black, yellow). See hookup
drawing.
Models/Dimensions Excess Gain Beam Pattern
SP100E and SP100R miniature opposed sensors have a slim right-angle design
which allows them to be mounted in very tight locations. The thin, exible rib-
bon cable which exits from one corner may be run in any direction away from
the sensing point. The SP100E and R have a wide beam angle for forgiving
line-of-sight alignment. Alignment is easily made exact (and monitored) using
the AID™ LED on the MICRO-AMP module.
OPPOSED Mode Sensors
Models SP100D and SP100DB are general-purpose miniature diffuse sensors
which detect the reection of their own light from the surface of an object. The
SP100D is a right-angle design which is generally held in place using a #4 (3mm)
screw. The SP100DB ("B" = Barrel) is an in-line threaded barrel which typically
mounts through a 3/8" (10mm) diameter hole using the lock nuts which are sup-
plied. The optical response characteristics of these two sensors are identical.
2
SP100D
SP100C SP100CCF
SP100DB
DIFFUSE Mode Sensors
Temperature range for all miniature modulated remote sensors is 0 to 70 degrees C (+32 to 158 degrees F).
Sensors are epoxy-encapsulated and optics are hermetically sealed.
Sensors for use with MA3 and MA3P Modulated Ampliers
CONVERGENT Mode Sensors