Filter
Top Products
Set up the loudspeaker
We recommend that you follow
this procedure:
– Disconnect your system from the
mains supply.
– Place the loudspeakers in your
setup.
– Set the switches to the correct
setting. This is explained in ‘Adapt
the loudspeakers to your setup’
(page 6).
– Connect your speaker system.
– Connect the entire system to the
mains again.
If you mount the loudspeaker on a
wall bracket, you cannot assemble
the base to the loudspeaker.
Cautions
– Make sure that the loudspeakers
are placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!
– The loudspeakers can only be
switched off completely by
disconnecting them from the
wall socket.
– The loudspeakers are designed
for indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– Remember that all speakers in a
setup must be connected to a
mains outlet, and that they are
designed to be connected to the
mains at all times, as this allows
them to switch on automatically.
– Do not attempt to open the loud-
speaker. Leave such operations
to qualified service personnel!
Column and base
It is easiest to assemble the base and
the speaker column if the loud-
speaker is placed on the two foam
packaging blocks – as shown.
Remove the small plastic cylinder
from the threaded end of the loud-
speaker, and push the base onto
the threaded end. Fasten the base
to the column with the washer and
nut. Tighten the nut carefully.
4
NOTE! The type number of the
loud speaker appears on the label
which is placed on the inside of the
socket panel cover.