Filter
Top Products
Daily use
When you have finished setting
up the loudspeaker as
described on the following
pages, connect the entire
system to the mains.
Loudspeaker protection
The loudspeaker is equipped with a
thermal protection system which
prevents damage from overheating.
If an error occurs – or the speaker
units become overheated – the
system automatically switches the
loudspeaker to standby.
To restore the sound:
> Disconnect the loudspeaker from
the mains supply.
> Allow the system time to reset or
cool down (approximately 3–5
minutes).
> Reconnect the loudspeaker to
the mains supply.
Should the problem persist,
contact your Bang & Olufsen
retailer.
To clean the loudspeaker
Clean dusty surfaces using a dry,
soft cloth. If necessary, remove
grease stains or persistent dirt with
a lint-free, firmly wrung cloth,
dipped in a solution of water
containing only a few drops of
mild detergent, such as washing-
up liquid.
Never use a vacuum cleaner to
clean the exposed speaker
membrane in the acoustic lens.
However, the loudspeaker front
cloth may be cleaned with a
vacuum cleaner with a soft brush
nozzle, and set to the lowest level.
Never use alcohol or other solvents
to clean any parts of the loud-
speaker!
To switch on and off
When you switch on your Bang &
Olufsen system, the loudspeaker
switches on simultaneously, and
when you switch the system off
again, the loudspeaker also
switches to standby.
Caution: Do not touch the
exposed speaker membrane in the
acoustic lens!
!
3