Azden SGM-PII Headphones User Manual


 
Thank you for purchasing the Azden SGM-P II
microphone. Designed for video and audio pro-
fessionals, the SGM-P II is a uni-directional shotgun
microphone with a wide frequency response and low
noise levels.
Power:
The SGM-P II must be powered by Phantom-
Power. To power the unit, connect an XLR cable to
the microphone from a voltage source that supplies
between 11 and 52VDC. (see wiring diagram below)
MIC Output:
The SGM-P II has a balanced 3-pin XLR
connector.
Shoe-Mount Holder:
The SGM-P II is supplied with a camera-
mountable mic holder. Snap the near portion of the
microphone into the holder. To secure the holder,
slide the holder into the camera shoe and tighten the
thumbwheel by turning it clockwise.
SPECIFICATIONS:
Electret Condenser Microphone
Frequency Response 80-18,000Hz
Sensitivity –33dB at 1kHz (0dB=1V/Pa)
Impedance 130 Ohms at 1KHz
MAX SPL (Input Level) 120dB SPL (1kHz at 1% T.H.D)
Signal-To-Noise Ratio 70dB. (1kHz at 1Pa)
Power (Phantom-Power) 11
52VDC
Current
2.4mA
Weight 90g
3.6oz
Dimensions
21mm x 207mm
0.827 x 8.27 inches
Connector 3-PIN XLR
Supplied Accessories Shoe-Mount Holder,
Wind Screen, Pouch
Frequency Response Super-Cardioid Polar Pattern
Due to constant improvements, specifications are subject to change without notice.
Shield
Positive (Hot)
Negative (Cold)