Filter
Top Products
3
Maintenance and Care
Handling Care for Ni-MH battery
1 To prevent the battery break, carefully ready this manual.
2 The operation environment of battery is 2060. If the operation temperature is out of this
range, the battery may damage.
3 Don't leave the battery inside of car under direct sunshine, don't face the battery for direct sunshine
and don't keep the battery beside heater. Also, don't use the batter at very cold place, which is zero
degree or less than zero.
Such environment may make short life and damage goods.
4 Don't put the battery in the slot water and watery.
5 Inside of battery, it includes the alkaline liquid. If the liquid touches to hands, skin etc., immediately
washes them.
Prohibition:
Don't throw away the battery in the fire and don't make warm it.
Don't soldering it directly.
Minus and plus terminal, don't connect by needle, cable etc
Don't set the battery + - terminal in reverse.
Don't disassemble and assembly.
Don't throw away and put high pressure on it.
Recharging user only our accepted recharge.
Don't insert battery into car external battery socket, wall socket.
Don't user any other equipment without our permission.
Do not attempt to service this unit yourself as opening or removing covers may expose dangerous
voltage or otherhazards. Refer all servicing to qualified service personnel.
Clean only with a dry cloth. Do not use detergents or other liquids.
Replacement parts
When replacement parts are required, be sure the service technician uses replacement parts
specified by the manufacturer or those that have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
Safety check
Upon completion of any service or repairs to this unit, ask the service technician to perform safety
checks to determine that the product is in proper operating condition.
14
Microphone Suggestions
Regulation
In addition to the attached uni-directional microphone, any one of many fine external microphones
can be used. In the case of head or collar worn mics is that it would be possible to increase the
gain (volume) without adding feedback noise. This is due to the proximity of the mic element to the
speaker's mouth. Any of the following Azden microphones will produce excellent results.
EX-503 Omni-directional Lavalier EX-505U Uni-directional Lavalier
HS-12 Behind head version of HS-1 1 HS-11 Uni-directional Headset HS-9 Omni-directional Headset
CM-20D Uni-directional Collar-worn
CE Declaration of Conformity
This equipment is in compliance with the essential requirements and other
relevant provisions of Directives 89/336/EC or 73/23/EC.
Before putting the equipment into operation, please observe the respective
country-specific regulations!
FCC Rules
This equipment has been tested and found to comply with the limits for of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4) Consult the dealer or an experienced radio/TV technician for help. The users manual or
instruction manual for an intentional or unintentional radiator shall caution the user that changes
or modifications not expressly