Azden 411UDR Headphones User Manual


 
51BT with Lavaliere or Headset:
With someone talking into the microphone, turn the volume on the mixer or amplifier to the desired level. If
there is too much, or not enough gain, lower or raise the volume on the receiver. If the sound is distorted,
lower the input gain on the transmitter.
51BT with Instrument cable for electric guitars or basses (MP-1H):
Plug the cable into the guitar or bass. Set the instrument volume to the midway point. While playing the
instrument, turn the volume on the mixer or amplifier to the desired level. If there is too much, or not enough
gain, lower or raise the volume on the receiver. If the sound is distorted, lower the input gain (4) on the
transmitter.
51XT: With someone talking into the microphone, turn the volume on the mixer or amplifier to the desired
level. If there is too much, or not enough gain, lower or raise the volume on the receiver. If the sound is
distorted, lower the input gain on the transmitter.
51HT:
With someone talking/singing into the microphone, turn the volume on the mixer/amplifier to the desired
level. If there is too much, or too little gain, adjust the volume on the receiver. If the sound is distorted, move
the microphone further away from the sound source. Make sure that the LED is green when the mic/transmit-
ter is turned On. When the battery is low, the LED turns red indicating that the battery needs to be changed.
NOTES:
- All “Performance Series” transmitters will work continuously for approximately 6-8 hours using an
alkaline battery.
- Remove the battery if the transmitter will not be used for a long period of time.
- Do not use or store the system in areas of high temperatures or humidity.
- Do not use this system near a broadcast station, airport, or airplanes, it may cause interference. If you
are interfering with other transmissions you must turn off the system.
- These systems contain no user serviceable parts. If unauthorized service is performed it may void the
warranty.
(8)