Filter
Top Products
input of another channel on the same amplifier, or of
another amplifier with true balanced inputs.
The pass-through output does
not convert unbalanced sources
to a true balanced signal.
If you wish to drive an unbalanced amplifier from
the pass-through outputs, you will need to use
XLR-to-RCA adapters. These should be configured
so that pin 1 of the XLR is connected to the shell of
the RCA connector, and pin 2 of the XLR is
connected to the center pin of the RCA connector.
Loudspeaker Outputs
The heavy-duty output
terminals of the Ayre V-6x
work best with speaker cables
using spade lugs.
The Ayre V-6x drives the loudspeakers with
balanced outputs. Since none of the output
terminals are grounded, connecting any of them to
ground may result in damage to the amplifier.
Do not connect the loudspeaker
outputs to any speaker switch-box,
accessory, or test equipment that has a
common ground connection.
5
Trigger In/Out
Input Sel
Unbal
Bal
Pass-Through
Output
Fuse + - Fuse
Input Sel
Unbal
Bal
Pass-Through
Output
Fuse + - Fuse
Input Sel
Unbal
Bal
Pass-Through
Output
Fuse + - Fuse
Input Sel
Unbal
BalPass-Through
Output
+ FuseFuse -
Input Sel
Unbal
BalPass-Through
Output
+ FuseFuse -
Input Sel
Unbal
BalPass-Through
Output
+ FuseFuse -
¡Attention! — Balanced Outputs
Do Not Connect Output Terminals to Ground
Volts
50/60Hertz
1800 W Max
V-6 Power Amplifier
S.N.
A y r e
Boulder, Colorado USA