Filter
Top Products
turntable, the custom cables must be made flexible
to allow proper motion of the suspended sub-chassis.
This is normally done by removing a section of the
cable’s outer jacket near the turntable.
A custom phono cable using a single cable may also
be used as shown below:
Please note that this configuration requires cabling
that has a multiple of four conductors plus a shield.
If there are eight or twelve conductors, they must be
paralleled to create four composite conductors. Also,
a short section of the cable jacket must be removed
at each end of the custom cable to allow the
connectors to be physically separated.
Tonearms with a Mini-DIN Connector
Another common tonearm configuration has a 5-pin
mini-DIN connector below the turntable base. This
12
1
1
Shield
Male XLR
To
Turntable
To Phono
Preamplifier
Ground Wire
Spade LugSpade Lug
Male RCA