Filter
Top Products
If the ASWCSTALK is mounted on the right side of the steering column follow the
instructions below. (Auto-detect must be done rst)
1. Turn the ignition on
2. Press the MODE on the ASWCSTALK for 10 seconds
3. Then press volume up for 2 seconds
4. The ASWCSTALK is now congured for the right side
Troubleshooting the Auto Detect Mode
So you tried the auto detect feature and at the end the led did not stay on solid
red, it started ashing, or the steering wheel controls did not function properly.
That means the interface did not detect the ASWCSTALK or the proper radio.
Follow these steps to determine what happened:
First some basic tips:
1. Verify that you have 12 volt accessory and a good ground to the
ASWCSTALK and interface.
Once all the information above has been veried and correct, you will need to
put the interface back into auto-detect mode. Follow the instructions from “If the
ASWCSTALK was installed before” section above, however this time take notice
of the led ashes in steps 5 and 6.
4