Filter
Top Products
www.avenview.com
8
1.8 Installation
To setup Avenview VGA-C5A-R follow these steps for connecting to a device:
1. Connect VGA display to VGA-C5A-R
2. Connect CAT5/CAT6 cable between Transmitter (VGA-C5A-S or VGA-C5SP-4 or VGA-C5SP-8) and
Receiver (VGA-C5A-R)
3. Ensure that cables are tightly connected
4. Plug in 5V DC power cord to the power jack of the Receiver VGA-C5A-R.
5. Plug in 5V DC power cord to the power jack of the Transmitter VGA-C5A-S, or VGA-C5SP-4 or
VGA-C5-SP-8.
1. If a blurred video is seen or even worse, not displayed at all, try to adjust the EQ and Gain
rotary controls to improve the cable skew. GAIN rotary controls are designed for gain control,
and EQ rotary controls are designed for equalizing the wave form of the receiving video signal.
It is suggested to begin with adjusting the rotary control of EQ to get the input video displayed
first, and then the GAIN according to the video you see on the screen.
2. RGB delay control [De-skew] offers the flexible functionality to allow skew compensation
among VGA R, G, B signals due to long transmission or thru low quality cable. By adjusting the
rotary switch to choose R, G or B color channel at first, then use the push buttons to increase or
decrease the delay in the corresponding color channel. There are totally 31 steps, each step
with 2ns difference, for adjusting the delay between each color individually. Then the graphics
quality can be further assured.