Filter
Top Products
Recommended Additional Installation Materials
• Power Drill • Tape measure
• Carpenters Level • Small ladder (depending on ceiling height)
• Nail Set • Hammer
• Pencil • 32 2.5” 4D finish nails
• Straight Edge • 256 .75”-1” drywall screws
Elite Pro System EPS-168T General Information
B22 ProPanel Installation Guide
➋
Install four impaling clips within marked B22
ProPanel location using drywall screws.
Exact placement of each clip is not necessary.
➊
Mark intended location of each B22
ProPanel on the wall or ceiling.
Marked panel
outline
➌
Start the B22 ProPanel 5/8” above its intended
final height and press downward at a 45° angle
until the panel is flush with the wall surface.
TIP
For permanent mounting, apply Tubetak Pro
adhesive to the back of the B22 ProPanel
before completing Step 3.
CAUTION
Always use Tubetak Pro on the back of the
panel when attaching it to the ceiling.