Filter
Top Products
9 10 11
14
13
12
Quick Guide
NOTE: The XM Radio ID does not use the letters I, O, S, or F.
3 Activate your service:
• Browse to http://activate.xmradio.com and follow the instructions.
OR
• Call 1 800 XM RADIO (1-800-967-2346).
4 When your service is activated, your Xpress
RC
will receive all channels.
This usually takes 10 to 15 minutes, but may take up to an hour. Your radio
must remain on until activated.
Using your Xpress
RC
Listening to XM
Enter a channel
1 Turn the knob to scroll through the list
of channels.
2 You’ll see the channel logo and cur-
rent artist. In a few seconds,
the current song title appears.
TIP! You can change the display mode to
show both the current channel
and all channels. Refer to Changing the
display in your user guide.
3 Press the XM button to select a channel.
TIP! You can congure Xpress
RC
to automatically tune to the channel you scroll to.
Refer to page 32 for instructions on how to eliminate the need to enter your selection.
View a category
With so many channels to choose from, XM Satellite Radio has organized them into
categories to make it easier for you to nd the ones that suit your taste.
1 To view a category, press or .
2 Scroll through the category to nd the channel you want.
3 Press the XM button.
TIP! To briey listen to each channel in the category, select Scan, then press the XM
button.
Change the display mode
You can view multiple channels on the display to see what else is playing.
Choose from:
To change the mode, press display.
TIP! When in split screen with the channel list, you can scroll through the list
of channels, just like when it appears on the full screen. Press or to change
categories. Press the XM button to select a channel.
TIP! Press jump to change to the previous channel.
split screen with channel listsingle current channel
split screen with previous
Set your favorite channel
You can assign up to 10 of your favorite channels to the number buttons so you can
quickly access them.
To assign a favorite channel to a button:
1 Tune to the desired channel.
2 Be sure you are in Favorite Channels
mode. Press fav until Favorite Channels
appears in the title bar.
3 Press and hold the number button you
want to use for that channel.
To listen to a favorite channel:
1 Be sure you are in Favorite Channels
mode. Press fav until Favorite Channels
appears in the title bar.
2 Press the number button where the desired channel is programmed.
TIP! To see your list of Favorite Channels, press or . Select a favorite and press
the XM button to listen to that channel.
FCC Statement
Please note that the power cable that has been supplied with your device is supplied with permanently
attached ferrite beads. It is the responsibility of the user to use the power cable with the ferrite beads.
The user is cautioned that changes or modications not expressly approved by XM
Satellite Radio Inc. can void the user’s authority to operate this device. This device complies with Part 15 of
the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the installation instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna of the aected receiver.
• Increase the separation between the XM equipment and the aected receiver.
• Connect the XM equipment into an outlet on a circuit dierent from that to which the aected receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! The FCC and FAA have not certied this Satellite Radio Receiver for use in any aircraft
(neither portable nor permanent installation). Therefore, XM Satellite Radio cannot support this type
of application or installation
SA10316
XM name and related logos are registered
trademarks of XM Satellite Radio Inc. A ll
other trademarks are the property of their
respective owners.
Delphi Corporation
1441 West Long Lake Road
Troy, Michigan 48098-5090 U.S.A.
1.877. GO.DELPHI
www.delphi.com
Printed on Recycled Paper
© 2007 Delphi Corporation. All rights reserved.
Step 4: Turning on your Xpress
RC
.
1 Turn on your car radio.
2 Insert the cassette adapter.
NOTE: If you are using the XM SureConnect or the FM Direct
adapter, refer to Turn the FM modulator on/o on page 50 for
more information.
3 Turn on your Xpress
RC
.
NOTE: You may experience a brief delay while your Xpress
RC
powers up. If you press
the power button during this time, you will see a “Please Wait” message.
Activation
Before you can listen to any of XM’s great channels, you must rst activate your
Xpress
RC
.
1 Make sure your Xpress
RC
is properly installed and receiving the XM
signal so that you can hear the audio on channel 1.
2 Make a note of your XM Radio ID. You can nd it:
• On XM channel 0
• On the rear package label
• On the label on the back of your Xpress
RC
DPSS-07-E-074
XM-9800-0125-00