Filter
Top Products
Congratulations on your purchase of the
Prestige
High Performance
Subwoofer. The
Prestige
Subwoofers are designed to provide you with high
quality Bass reproduction required to make your car audio system perform to
its full potential.
PRESTIGE
Subwoofer Features
l Dual 4-Ohm voice coil for maximum flexibility and performance
l Low-Q parameters for Isobaric and small sealed box enclosures
l Vented magnet for improved performance
l Gold-plated binding posts that can accept up to 10-gauge wire
l Long throw suspension assembly
l Poly-carbon woofer cone
l Chrome basket
SUBWOOFER PARAMETERS
PSW-10DC PSW-12DC
Nominal Power Rating 225 Watts 260 Watts
Maximum Power Rating 450 Watts 525 Watts
Ferrite Magnet 30 Ounce 40 Ounce
Frequency Response 20 Hz-2.5 kHz 20 Hz-2.5 kHz
Resonant Frequency (F/O) 32 Hz ± 20% 20 Hz ± 20%
VC Diameter 1.5" 2.0"
Sound Pressure Level 89 dB ± 1.5 dB 90 dB ± 1.5 dB
Xmax 6mm 7mm
Nominal Impedance 4 Ohms x 2 4 Ohms x 2
DCR 3.7 Ohms 3.4 Ohms
Speaker Weight 3.0 kg 4.3 kg
WARNING: High-powered car audio systems may produce sound
pressure levels that exceed the threshold at which hearing
loss may result. They may also impair a driver’s ability to
hear traffic sounds or emergency vehicles. Use common
sense and practice safe listening habits when listening to
your audio system.
DUAL VOICE COIL WIRING
CAUTION: Never connect only one voice coil of a dual voice coil woofer.
Both must be driven at the same time for proper operation.
Never connect an amplifier to an impedance load lower than
it is rated to handle.
SERIES/PARALLEL MONAURAL CONNECTION
Parallel
wiring for a single, dual-voice coil 4-Ohm woofer in a monaural system will
result in a total impedance load of 2 Ohms at the amplifier, (See Fig. 1) if your
amplifier is rated to drive 2 Ohms in bridged or one-channel operation. If each of
2