Filter
Top Products
These factory programmed settings can be prioritized based on an individual's
frequency of use. (i.e. pressing both buttons simultaneously to activate channel 1.
arm/disarm etc.) by following the normal programming instructions below.
Please note when changing the button sequences of the factory settings, it is
necessary to perform steps 5. 9, and 12 three times using "transmitter A ", followed
by one time using "transmitter B".
PROGRAMMING TRANSMITTERS:
It is important to remember that during programming, each individual step of the
procedure must be executed within 15 seconds of the previous step. When the 15
second time limit is allowed to expire. the system will automatically exit program
mode. This is indicated by a long "chirp" from the siren.
Additionally. any time the ignition key is turned off while programming. the system
will immediately exit program mode. This is also indicated by a long "chirp" from
the siren.
TO PROGRAM ADDITIONAL TRANSMITTERS:
1. Enter the vehicle. and turn the ignition key to the "on" position.
2. Move the valet/bypass switch on -off -on -off -on then off.
3. The dash L.E.D. will flash one time, and the siren will "chirp" one time. indicating
the system is ready to accept programming for channel 1. or the arm/disarm and
panic functions.
4. You can assign any of the three transmitter button functions listed below to
channel 1.
a) Pressing button #1 on the keychain transmitter.
b) Pressing button #2 on the keychain transmitter.
c) Pressing both buttons simultaneously on the keychain transmitter.
5. Press and hold the selected choice a. b. or c above, until the siren emits a long
"chirp" to confirm that programming of channel 1 was successful.
L
128-5491
2 of 6