Filter
Top Products
1
HINTS FOR CORRECT AND SAFE OPERATION
This CD Changer is designed to be operated only on 12 volt DC
negative ground systems. The unit can not be used on 24 volt or
positive ground systems.
TEMPERATURE
The unit may not operate correctly in extremely hot or cold
temperatures. It is equipped with a built-in thermal protection
circuit which will stop operation of the unit when the temperature
reaches the pre-set level. If this should happen, the unit will
resume operation when the vehicle returns to a normal tempera-
ture range.
Remove the magazine from the unit when it is not being used
during hot weather. If the discs are left in an extremely hot car they
may warp. If the CD changer is not used for long periods of time,
remove the compact discs from the magazine, and store them in
their cases.
CONDENSATION
Moisture can condense on the laser lens of the CD changer during
rainy and humid days, or right after the heater is turned on in the
car (if the changer is mounted in the passenger compartment). If
this should happen the unit will not operate correctly. To remedy
the situation, remove the discs from the unit and wait approxi-
mately one hour. During this time the moisture will evaporate and
the unit will operate normally.
INTERRUPTIONS IN SOUND (Skipping)
The sound from the unit may "skip" and be interrupted if the
anti-vibration springs are not set correctly, if the changer is
mounted in excess of a 15° angle, or when travelling on very rough
road surfaces. If this should occur, check for errors made during
installation or wait for the road surface to improve.
3" (8cm) CD-SINGLES
This unit is not designed to play 3" (8cm) CD-Single discs.
Inserting a 3" disc into the magazine, either with or without a 3" disc
adaptor, can damage the changer and the disc. Such damage will
not be covered by the Warranty on this product.