Filter
Top Products
SETTING THE CLOCK
1. Switch the vehicle ignition “on” and radio “off” (time display will show on the LCD panel).
2. Press and hold the Time/Frequency Selector (T/F) bu button. At the same time, turn the Manual Tuning Control 7 to the left to
adjust the hours (including “AM” or “PM” indication) or to the right to adjust the minutes.
3. After setting the correct time, release the Time/Frequency Selector.
-4-
NOTE: Never leave a cassette engaged in the player when not
in use. Doing so can cause damage to the cassette
and/or mechanism of the unit. Always press the eject
button and remove the cassette before leaving the ve-
hicle.
bt CD/AUXILIARY INPUT SELECTOR (CD)
An auxiliary input jack is provided on the rear of this unit to ac-
cept the audio from an additional source such as a portable CD
player. Connect the audio output from the source unit to the
cable at the rear of the chassis using an appropriate audio patch
cable (available at most radio supply stores). To select play of
the source connected to the input jack, press the CD/Auxiliary
Input Selector button. The indication “Cd” will appear on the
display panel and the input connected to the unit will now oper-
ate through the audio system of the radio. Use the volume,
balance and tone controls of the radio to adjust the sound as
desired.
bu TIME/FREQUENCY SELECTOR (T/F)
During radio or CD/Auxiliary Input operation, press this button to
call the time display on the incorporated quartz clock. Pressing
the button again or activating any tuning function (during radio
operation) will return to frequency or “Cd” display.
During tape operation, the time display will always be shown.