Filter
Top Products
P/N 8007132
Page 7 of 10
Rev. B
Step #3 INSTALL CONSOLE TO FLOOR OF VEHICLE
⇒ BEFORE DRILLING ANY HOLES VERIFY THAT DRILL BIT WILL NOT ENTER
INTO FRAME RAIL(S) OF VEHICLE, ELECTRICAL WIRES, FUEL LINES,
BRAKE LINES, HOSES, EXHAUST SYSTEMS OR ANY OTHER ITEMS THAT
WILL IMPAIR OPERATION OF VEHICLE. THE BOLTS OF THE FLOOR
CONSOLE MUST SECURE TO FLOOR PANEL OF VEHICLE. CLIMB UNDER
VEHICLE AND LOOK TO VERIFY THAT HOLES WILL BE IN PROPER
LOCATIONS.
⇒ Set console on floor of vehicle and mark where holes are to be drilled. Drill
small 1/8” pilot holes to verify that drill holes are in proper locations.
⇒ After verifying that 1/8” pilot holes are in proper locations, use ¼” drill bit to
enlarge 1/8” pilot holes.
⇒ Set console on floor over holes.
⇒ Place bolts through feet of console and into holes previously drilled.
⇒ Place one large fender washer over each of bolts and attach nuts.
⇒ Tighten nuts down securely. Have second person inside vehicle hold bolts
securely with box-end wrench while person underneath vehicle tightens down
nuts.