Filter
Top Products
1}1
indicator number on the display panel will flash). Press the button again
momentarily to stop the Pre-set Scan operation and remain on the
selected frequency. Pressing the button for longer than 1 second will
activate the Auto-Store Tuning, which will automatically scan the band
and enter the six strongest stations into the six pre-set memory positions
for each band. If you have already set the pre-set memories to your
favorite stations. activating the Auto-Store feature will erase those
stations and enter the new strong stations. This feature is most useful
when travelling in a new area where you are not familiar with the local
stations.
~ STATION PRE-SET MEMORIES
To set any of the 6 pre-set memories, use the following procedure:
1. Turn the unit on and select the AM band.
2. Select the first station to be pre-set using the Manual Tuning @ & W
or SEEK ~ functions.
3. Press the pre-set button to be set and continue to hold the button in.
The volume will be muted for approximately 2 seconds and then
return. The station is now set into that pre-set button. To recall that
station. press the button momentarily.
4. Repeat the above procedure for the remaining 5 pre-sets on the band.
5. Select the FM 1 band and enter 6 FM memories using the same
procedure as above. In similar fashion, enter 6 pre-set memories on
the FM2 band.
([D LIQUID CRYSTAL DISPLAY PANEL
The Liquid Crystal Display(LCD) panel displays the frequency. time and
activated functions.
Note: It is a characteristic of LCD panels that, if subjected to cold
temperatures for an extended period of time. they will take longer
to illuminate than under normal conditions. In addition. the
visibility of the numbers on the LCD may slightly decrease. The
LCD read-out will return to normal when the temperature
increases to a normal range.
Q?J TIME/FREQUENCY SELECTOR (T/F)
During radio operation. push this button to call the time display on the
incorporated quartz clock. Pressing the button again will return to
frequency display, or it will automatically return after approximately 5
seconds.
~~~~
SETTING CLOCK
1. Switch vehicle ignition "on" and radio "off"(time display will show
on LCD panel (jD).
2. Press and hold the Time/Frequency Selector(T /F) @. At the same
time, press the Down Tuning button I]) to adjust the hours, then the
Up Tuning button (6) to adjust the minutes.
3. After setting the correct time, release the Time/Frequency Selector.
~::
" """"
.'~1~
.',v
":.~...
o.:-£,.j~
.~~'~':
~~
~~~~;~~