Filter
Top Products
7
PROCEDURE FOR VERTICAL INSTALLATION
NOTE:
If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 6), start with step 2.
Hexagonal bolt
with washer base (M5 x 8)
Bracket (R)
Bracket (L)
4
2
Attach bracket (L) and bracket (R) to each side of the unit,
using the hexagonal bolts with washer base (M5 x 8).
Mount the unit in place, using four self-tapping screws
(M5 x 12).
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Set the 4 anti-vibration springs to position "V".
Determine the mounting location, and drill four mounting
holes.
3
1
Never mount the unit near the fuel tank.
Drill holes 4 mm in diameter.
position "V"
Self-tapping screw
(M5 x 12)
Bracket (R)
Bracket (L)
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.