Filter
Top Products
2
HINTS FOR CORRECT AND SAFE OPERATION
This CD Changer is designed to be operated only on 12 volt DC
negative ground systems. The unit can not be used on 24 volt or
positive ground systems.
TEMPERATURE
The unit may not operate correctly in extremely hot or cold
temperatures. It is equipped with a built-in thermal protection circuit
which will stop operation of the unit when the temperature reaches
the pre-set level. If this should happen, the unit will resume operation
when the vehicle returns to a normal temperature range.
Remove the magazine from the unit when it is not being used during
hot weather. If the discs are left in an extremely hot car they may
warp. If the CD changer is not used for long periods of time, remove
the compact discs from the magazine, and store them in their cases.
CONDENSATION
Moisture can condense on the laser lens of the CD changer during
rainy and humid days, or right after the heater is turned on in the
car (if the changer is mounted in the passenger compartment). If
this should happen the unit will not operate correctly. To remedy the
situation, remove the discs from the unit and wait approximately one
hour. During this time the moisture will evaporate and the unit will
operate normally.
INTERRUPTIONS IN SOUND (Skipping)
The sound from the unit may "skip" and be interrupted if the anti-
vibration springs are not set correctly, if the changer is mounted in
excess of a 15° angle, or when travelling on very rough road
surfaces. If this should occur, check for errors made during
installation or wait for the road surface to improve.
3" (8cm) CD-SINGLES
This unit is not designed to play 3" (8cm) CD-Single discs. Inserting
a 3" disc into the magazine, either with or without a 3" disc adaptor,
can damage the changer and the disc. Such damage will not be
covered by the Warranty on this product.