Filter
Top Products
128-8777
6 of 8
6
After removing the three #0
point phillips screws shown
pry apart case with the
edge of a finger nail or a
small common screwdriver.
Keep hold of the metal key
ring loop to prevent it's loss
as it will separate from the
transmitter case.
Carefully remove the
discharged battery by sliding
it out from under the clip in
the direction indicated by the
arrow in the diagram below.
Properly dispose of the
discharged battery and
insert a new CR2032 taking
care to arrange it so that the
+ is facing up toward the +
symbol on the battery clip.
Reassemble in the reverse
of above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE:The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment