Filter
Top Products
128-8802
2 of 4
Battery Replacement
After removing the three #0 point
phillips screws shown, pry the
case apart with the edge of a
finger nail or a small common
screwdriver. Keep hold of the
metal key ring loop to prevent its
loss as it will separate from the
transmitter case.
Carefully remove the discharged
battery by sliding it out from
under the clip in the direction
indicated by the arrow in the
diagram below. Properly dispose
of the exhausted battery and
insert a new CR2032 battery
taking care to arrange it so that
the + is facing up toward the +
symbol on the battery clip.
Reassemble in the reverse of
above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause
undesired operation.
NOTE:The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment.