Filter
Top Products
128-8698
6 of 8
6
After removing the two #0 point phillips
screws shown pry apart case with
the edge of a finger nail or a small
common screwdriver. Keep hold of the
metal key ring loop to prevent it's loss
as it will separate from the transmitter
case.
Carefully remove the discharged
battery by sliding it out from under the
clip in the direction indicated by the
arrow in the diagram below. Properly
dispose of the exhausted battery and
insert a new CR2032 taking care to
arrange it so that the + is facing up
toward the + symbol on the battery clip.
Reassemble in the reverse of above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment.