Filter
Top Products
OWNER’S MANUAL
FS3D62 Soundbar
with
AudioSource®
13970 SW 72nd Ave.
Portland, OR 97223
877.715.5439
ww
w.audiosource.net
FS3D62 Owner’s Manual 8100.FS3D62A
1. Power/Standby Switch
The front panel power switch switches the FS3D62 between on or
standby mode. When in standby mode, the LED light will be red.
When the unit is switched on, the red LED light will go off.
2. Remote Control Sensor
This sensor detects the controls signaled from the remote control.
Take care not to block its direct line of sight to the remote control.
3. Source button
This button selects between the Aux Input, RCA Input and Optical
Input. When using the Optical Input, make sure the source unit the
cable is plugged into is in Digital PCM (2 Channel) Mode. Please
refer to your source’s operating manual when using this mode.
4. Volume Down/Up Buttons
These buttons decrease or increase the volume of the FS3D62. Press the left
button to decrease volume; press the right button to increase the volume.
5. Mode Select
This button cycles through the 3 preset audio settings: Normal, Movie and
Music. Using the presets are a matter of personal taste; please feel free to
experiment until you find a setting that suites your personal tastes. It is
perfectly fine to listen to music using the “Movie” mode or to listen to a
movie in “Music” mode.
Figure 1. Front Panel
Figure 2. Rear Panel
6. Power Adapter Jack
Connect the 26V power adapter plug in this jack.
7. Aux Input
This input will accept 3.5mm stereo plugs from MP3 players,
computers or the headphone output of TV’s that do not have
RCA style jacks. Select “Aux” on the front panel Source
button to use this input.
8. Optical Input
This input uses a fiber optic cable to transmit a digital signal to the FS3D62.
Use of this input is recommended for advanced users who are familiar with
the source’s OSD system. When using the Optical input, make sure the source
unit the cable is plugged into is in Digital PCM (2 Channel) Mode. Please
refer to your source’s operating manual when using this mode.
9. RCA Input
This input will accept RCA stereo plugs from DVD players,
cable boxes or any standard device with an RCA output. Select
“RCA” on the front panel Source button to use this input.
10. Line Output
This output can be connected to an external subwoofer using standard RCA
cables to add even more bass output to your listening experience. The output
of this jack will track the volume of your source.
11. Wall Mount
These convenient keyhole slots allow you to mount your soundbar to the
wall. Please ensure you use a drywall anchor rated for 20lbs. Each drywall
anchor should be placed 16” on center apart from each other; please
measure the distance of the keyhole slots on the back of the FS3D62 to ensure
accuracy. The keyhole slots accommodate #9 woodscrews or equivalent.
3
5
4
1
2
6
7
8 9
10
WARNING: DON’T PLUG AC CORD INTO
115V OUTLET BEFORE IT IS CONNECTED
TO THE POWER CONNECTOR ON THE
REAR OF THE UNIT.
11
AUX IN
RCA IN LINE OUT
OPTICAL
MODE
SOURCE