Filter
Top Products
Using the Controls/Back Panel
Manual/Auto Power Switch (Rear Panel)
In the Auto mode, the Amp Seven T will turn on automatically when an input signal is sensed. In the absence of an input signal, the
Amp Seven T will shut down automatically. (In the Auto mode, the front panel power switch should always remain in the on posi-
tion.) In the Manual mode, use the front panel power switch to activate the Amp Seven T.
Hooking up the Wires
Audio signals travel out of one component and into another, so all of your connections should go from out to in.
Line In
If you are connecting a preamp or other signal source to the Amp Seven T, connect the this signal source’s line out jacks to the
Amp Seven T’s line in jacks.
Bridging Switch
In addition to providing 200 watts RMS per channel in the stereo mode, your Amp Seven T can be used as a high power, 500 watt
RMS mono amplifier. Simply toggle the bridging switch from the stereo position to the mono position. For mono applications, use
only the right channel input. Similarly, use only the right channel input level control.
Be sure to observe the correct speaker connections for bridged applications. Because of the Amp Seven T’s high power output in the
mono mode, we recommend initially setting the right level control at minimum, and then adjusting the volume to the desired level.
Line Out/Thru
The line in/thru jacks are used to connect to other amplifier or component inputs, including when daisy chaining components. These
Stereo Setup
In this configuration, the bridging
switch is off for stereo operation.
Connect the line out jacks from a stereo
signal source to the line in jacks of your
Amp Seven T. Next, connect your speak-
ers to the terminals marked Speaker A
(observing proper polarity: red for "+",
and black for "-"). Connect a second
pair of speakers to the terminals marked
Speaker B. Select between the A and/or
B speakers using the front panel speaker
selector buttons.
Mono Setup
In this configuration, the bridging
switch is on. Connect the line out from
a signal source to the right line in of
your Amp Seven T. Connect your mono
speaker to the terminals of your Amp
Seven T, following the example in the
diagram opposite. Use the right level
control on the front panel to adjust
the volume.