AudioSource AMP1200 Stereo Amplifier User Manual


 
(4)
NOTES ABOUT HUM:
While the AMP1200 has been designed to minimize the possibility
of
hum in the audio system, it is still possible that a hum will occur
in
rare circumstances. Its safety grounding can create a path for
small
amounts of 60 Hz energy to travel trough the line-level audio
system
. While not dangerous, this energy can cause difficulty with
the
auto signal sensing circuit, and at the very least will interfere
with
the quiet enjoyment of your system. The first course of action
should
be trying to make sure that all of the audio components are
connected
to either the same electrical outlet, or at least into the
same
circuit branch. Next, cable TV systems are notoriously the
culp
rit, so be sure to try disconnecting all coaxial feeds that are
connected
to the system. If this solves the problem, install a coaxial
line
isolator and reconnect the system. In the very worst case, a
line-l
evel audio isolator/transformer connected to the line-in of the
sub
woofer amplifier will usually solve the problem.
SPECIFICATIONS:
Rated Power Output: 40 Watts per channel RMS at 8 ohms
Bridged Power Output: 80 Watts per channel RMS at 8 ohms
(8 ohm minimum)
Input Sensitivity: 380 mV for full output with all level
controls at max.
Input Impedance: 18K ohm
Frequency Response: 5 Hz to 72 kHz
Distortion: .005% THD 20 Hz-20 kHz @ 30W (8 ohm)
Distortion (Bridged): .010% THD 20 Hz-20 kHz @ 80W (8 ohm)
Channel Crosstalk: 80 dB
Signal to Noise Ratio: 105 dB A-weighted
Efficiency: 63%
Power Requirements: 115/230 VAC, 50 Hz/60 Hz
Stand-By Power Rating: 115V, 0.264W *
Auto Turn-On Sensitivity: 13.7mV
Dimensions: 16.7” W x 4” H (including feet) x 14.25” D
Weight: 30 lbs.
* The AMP1200 complies with the ENERGY STAR and CE EuP directive
TYPICAL 6 ROOM INSTALLATION
Impo
rtant Safety Instructions
To reduce the risk of electric shock, do not remove cover. No user service -
able parts inside. Refer servicing to qualified personnel. To reduce the risk
of fire and shock do not expose unit to rain or moisture. The unit should be
connected
to an earth grounded AC electrical socket. The unit should be
ope
rated in a well ventilated area. Minimum clearance is 2 inches from the
ventilation openings.
Note:
Unit is set at the factory for 120V operation. Be sure to change the fuse
(4A
rating) before switching to 230V operation.
Two Year Limited Warranty
AudioSource, a division of Peak Audio Group, warrants this product against defects in materials and workmanship for a limited period of time.
For a period of two (2) years from date of original purchase, we will repair or replace the product, at our option, without charge for parts. Customer
must pay for all labor charges associated with the removal and re-installation of speakers for the limited period and all parts and labor charges after
the limited warranty period expires. The limited warranty period for factory refurbished products expires after ninety (90) days from date of original
purchase. This limited warranty applies only to purchases from authorized AudioSource Retailers or Distributors. This limited
warranty is extended only to the original purchaser and is valid only to consumers in the United States.
Consumers are required to provide a copy of the original sales invoice from an authorized AudioSource Retailer or Distributor when
making a claim against this limited warranty. This limited warranty only covers failures due to defects in materials or workmanship that occur during
normal use. It does not cover failures resulting from accident, fire, flood, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation,
modification, service by anyone other than AudioSource, or damage that is attributable to Acts of God. It does not cover costs of
transportation to AudioSource or damage in transit. The customer should return their defective product, freight prepaid and insured,
to AudioSource only after receiving a Return Authorization.
Repair or replacement under the terms of this warranty does not extend the term of this warranty. Should a product prove to be defective in workmanship
or material, the consumer's sole remedies will be repair or replacement as provided under the terms of this warranty. If the defective product is discontinued
AudioSource may replace the product with an equivalent or superior product at its option. Any cost of re-installation or repair of wall
or ceiling surface is the sole responsibility of the customer and that cost shall not be the responsibility of AudioSource. Under no
circumstances shall AudioSource be liable for loss or damage, direct, consequential or incidental, arising out of the use of or inability
to use the product. There are no express warranties other than described above.
AM/FM RECEIVER