Filter
Top Products
© 2008 • All rights reserved. 23
DLA2/4/6 Speaker Level Audio Router
Press
& Hold
Press
& Hold
ROOM 1
ROOM 2
After 3 seconds the Maximum Turn-On Volume Level is saved.5.
Room LED and Volume LED’s blink four times (Room LED blinks RED).6.
The Room will turn back on to the volume level it was set to prior to setting the 7.
Maximum Turn-On Volume Level.
Turn the Room Off, then back On to achieve the Maximum Turn-On Volume Level.8.
Note: Setting the Maximum Turn-On Volume Level to the highest volume level will essentially
disable Maximum Turn-On Volume (the room will always come back on at the last volume
level prior to turning the room Off).
Page/Doorbell Volume Level
By programming the Page/Doorbell Volume Level for each room of the DLA system, the volume
levels for each of the rooms will jump to their programmed settings when the PAGE/DB INPUT of
the DLA2/4/6 is activated.
To set the Page/Doorbell Volume Levels for a room:
Press the 1. Room Button for the desired room.
Press
ROOM 1
ROOM 2
Set the desired Page/Doorbell Volume Level using the front panel Vol + and 2.
Vol - Buttons. Note: Any room whose LED is not lit (red or blue) will be considered Off
when setting the Page/Doorbell volume level.
Initiate a Page or Doorbell signal from the ELAN COM2 Communications Controller to 3.
check the volume setting. Adjust the volume as required.
Press and hold the 4. Room Button on the front panel (Room LED will turn off and all
Volume LED’s will go off).