Filter
Top Products
© 2007 • All rights reserved. 9
Storm Series In-wall Speakers
4. Once it has been determined that the cavity is free from obstructions, position the cutout
template and use a pencil to lightly trace the perimeter of the template.
5. Cut the opening using a keyhole saw, drywall router, or razor knife.
Mounting Speakers in Wall (Pre-Construction or Retro-Fit)
1. Remove speaker grille and place speaker face down.
2. Locate the speaker wire and pull through the wall opening.
3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY!
4. Insert the speaker into the opening in the wall (or Rough-in Bracket opening) and care-
fully tighten each of the six clamping screws, alternating diagonally between each screw
position to ensure proper fi t.
5. Aim the pivoting tweeter at the listening area.
7. Set the Treble or XOVER switch if applicable. See Setting Switches for details.
8. Replace the speaker grille.
Figure 3.11 -Mounting Speakers In Wall