ATON A82C Speaker User Manual


 
6 ©2007 • All rights reserved.
Storm Series Ceiling Speakers
• Five 2 conductor speaker wires run from the A/V Receiver
to each surround sound speaker.
A/V Receiver/Amplifier
Figure 3.7 - Wiring: Amplifi er to Speakers-Home Theater
Note 1: Low voltage wiring must be run in accordance with the National Electrical Code as well as any other applicable provi-
sions of the local building codes in your area. In some cases (such as commercial installations), running the wire in conduit
may be required. If you have any questions concerning the wiring of speakers in your home, contact your local building and
inspection department.
Note 2: It is recommended that you use quality CL-2 or CL-3 rated stranded speaker wire when installing ATON speakers.
Solid-core “Romex” type wire is not acceptable! Use at least 16AWG speaker wire for runs up to 100 feet, and at least 14 AWG
speaker wire for runs up to 200 feet. If you must cross high-voltage lines, always do so at a 90 degree angle to avoid audible
hum through the speakers!.
Note 3: When pre-wiring for ceiling speakers, it is essential to make direct wire runs from the head-end to each speaker. Do not
run speaker wires in series or parallel, and do not “daisy-chain” speakers to common wiring.