Filter
Top Products
10 ©2007 • All rights reserved.
Storm Series In-wall Speakers
Setting Switches
A62W/A82W TREBLE Switch
Once the speakers are wired, mounted, and positioned correctly, use the TREBLE switch (if
applicable) to fi ne-tune the speakers based on local environmental variables such as hardwood
fl oors, thick draperies, etc. Select the “+” position to increase Treble response or select the “-”
position if no increase is desired.
TREBLE
TREBLE
Figure 3.12 -TREBLE Switch
A82SW XOVER SWITCH
The Crossover switch adjusts the upper frequency limit of sound that emanates from the sub-
woofer. This switch has three positions: 80Hz, 120Hz, and 180Hz. Correctly setting the XOVER
level is paramount to a smooth transition between the main speakers and the subwoofer. Set-
ting this switch too low causes a gap to occur in the audio that makes the main speakers seem
disconnected from the bass, an audible separation of sound that does not seem natural. Setting
the switch too high causes bass to be produced too strongly because of overlapping frequencies
between the main speakers and subwwoofer. This causes a “muddy” sound and reduces the
overall clarity of the audio.
It is important to experiment with the XOVER switch upon initial setup to obtain the clearest,
smoothest sound possible. Try all three settings, and leave the switch in the location it
sounds best. See Figure 3-13.
80
80
120
120
180
180
X
O
V
E
R
X
O
V
E
R
Figure 3.13 -XOVER Switch