Filter
Top Products
Owner’s Manual
TSD-PA10VG
Mono Commercial Power Amplifier
AtlasSound.com – 4 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Rear Panel Description
TSD Input/Output connections are removable for easy system wiring. The connectors have a 3.5mm
pitch between pins.
1. DC Power Input - Each TSD that requires DC power comes with a 2 position connector for an
external 24VDC power supply (sold separately). Because of the TSDs low power consumption, a
singleexternalpowersupplymaypowermorethanoneTSD.Pleaserefertothespecications
on current requirements in milliamps to match with the appropriate power supply. Please observe
the polarity of the wiring to this connector. Note: It is acceptable to exceed the current
requirements of the TSDs but NOT safe to use a power supply that is below the current
requirement of the device.
2. Balanced Line Input - Connect balanced line level signals to the phoenix style connectors. Your
connection must be mated properly to the input connector or signal loss and/or noise may occur.
Note: Unbalanced line level inputs can also be used by connecting the (G) and (-) terminals
together.
3. Speaker Outputs - Connect the loudspeaker wiring to these terminals, observing the polarity
shownontherearofthechassis.Forlowimpedanceloads,usethe“COM”and4Ω terminals.
Forhighimpedanceloads,use“COM”andtheproperterminalforyoursystem(25/70/100V).Itis
recommended to keep the sum total of tapped loudspeakers to 10W.
4. Output Load Switch - For 8Ω & 4Ω loads place the switch into the 4Ω position. For 25/70/100V
speaker systems place the load switch into 25/70/100V position. Failure to do this may cause the
amp to go into protect.
5. Cable Management Retainer Points - Use the rear panel screws for connecting the included cable
retainers.EachTSDcomeswithtwocableretainersforsimpliedcablemanagement.
1 2 34
55
5 5