Filter
Top Products
3
Instruction Manual
230V 115V
Bass Level Control
Use this control to set the level of bass desired
Status LED
This will be green for "on" condition, amber for "standby"
Standby Switch
When in ON position, the amplifier will always be on. When in the
AUTO position, the amplifier will be in Automatic Standby Mode.
Crossover Control
An adjustable (40Hz to 140Hz) @ 18dB per octave low-pass
crossover.
Phase Switch
This switch allows precise acoustic matching with satellite speaker
systems whose output may be phase reversed. Try in both posi-
tions — use the position that results in the strongest bass output.
Crossover Switch
When in the NORMAL position, adjustment of the crossover can
be made by the Crossover Control. If being fed a pre-filtered or THX
signal, place the switch at the BYPASS position. (pages 5 and 9)
1
4
3
2
10
8
9
SB-1000 Subwoofer Rear Panel
Figure 1
1
9
11
8
7
12
5
7234 5
6
6
11
12
10
Low Level Output
The outputs allow daisy chaining of multiple subwoofers, or as a
return path back to the processor.
Low Level Input
Use the input to connect to the subwoofer or LFE line out from
your processor/receiver.
Product Serial Number
Write this number in the space provided on page 2 for future
reference.
Voltage Select Switch
Voltage switch for use in different countries. This switch will be set
when you receive the unit. Change this setting only when you are
sure your application requires it. For US, the switch should be set
to the 115V position.
On/Off Switch
Use this switch to turn the amplifier completely on or off.
AC Input
Use the included power cord to connect your amplifier to a wall
outlet.