Filter
Top Products
13
1. Select Control Panel in the Main group of the Program Man-
ager. Then select Drivers.
2. Select "Antex Audio Driver for Windows" from the list of in-
stalled drivers. Click on Setup.
3. To set adapter type:
"Antex Audio Driver Setup" displays the adapter types assigned
to adapters 1-4. Change the type by using the drop down
menus for each adapter. Information about the number of de-
vices, I/O address, and interrupt number are displayed to the
right of each adapter.
4. To set the number of devices, I/O address, or interrupt number:
Select Advanced in "Antex Audio Driver Setup". Select an
adapter to reconfigure.
Change the number of devices, I/O address, or interrupt num-
ber by selecting the appropriate buttons. Invalid choices are
displayed in gray. Note: The I/O address and interrupt must
match the jumper settings on the board. For more information
refer to JUMPER SETTINGS.
Test new settings by selecting Test.
NOTE: The driver version number and date displayed in the
middle left of the "Antex Advanced Setup" screen. Refer to this
information when reporting problems to Antex Technical Sup-
port.