Anchor Audio AN-100CMF1+ Speaker System User Manual


  Open as PDF
of 6
 
MADE IN USA
SIX YEAR WARRANTY
AN-1000X+ Speaker Monitor Owners Manual
AN-1000X+ TECHNICAL SPECIFICATIONS
(Specifications Subject to Change Without Notice)
ANCHOR AUDIO CUSTOMER SERVICE
800.262.4671
FOR ADDITIONAL INFORMATION
visit www.anchoraudio.com
6
Rated Power Output 50 watts continuous @ 4W
Max SPL @ Rated Power 107 dB @ 1 meter
Frequency Response 65 Hz – 20 kHz ± 3 dB
Speaker Type 4.5” woofer with shielded magnet,
10mm dome tweeter
AC Power Reqs. 110 – 125Vac, 50/60 Hz, 90W
Max
Export Model 208 – 240Vac, 50/60 Hz, 90W
Max
Dimensions
(HWD)
5.25” x 8.4” x 9”
(13 x 21 x 23 cm)
Weight 9.5 lbs / 4.3 Kg
Tone Controls
Bass +8 – 12 dB @ 100 Hz
Treble +10 – 12 dB @ 10 kHz
Inputs
Balanced female XLR, switchable phantom
power, 15 volts DC @ 6.8 kW
Mic-Level Setting Lo-Z
Line-Level Setting Bridging (10 kW)
Line Hi-Z, unbalanced, 1/4”-phone &
RCA
Outputs
Line (post fader) Lo-Z, buffered, RCA
Speaker 8W, unswitched, 1/4”-phone
Sensitivity For Rated Output
Line balanced -18 dBv (125 mVrms)
Microphone balanced -56 dBv (1.5 mVrms)
Line -18 dBv (125 mVrms)
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound
(Power LED Not Lit)
• turn POWER switch on
• plug in power cord
• check for blown fuse
No Sound
(Power LED Lights)
• check for output from source
• make sure all cables are completely plugged in
• increase volume control
Distorted Sound • check input cable connection
• lower input signal level
Excessive Hum / Noise • use shielded input cable
Mic Volume Too Low • set balanced input to mic-level
Blows Fuse w/ Auxiliary Speaker • shorted speaker cable
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM?
(Wireless Model Only)
No Sound • confirm transmitter power switch is set to on
• turn up volume control
• plug microphone into body-pack transmitter
• turn sound system on
• replace mic/transmitter battery
• make sure hands free mic cable is fully plugged into transmitter
Frequent Transmitter Dropouts • replace mic/transmitter battery
• move mic/transmitter closer to AN-1000XF1+
• change transmitter to different channel
 previous