Step 4
Operating the transmitter
After powering up the transmitter, the transmit light will go on for approximately
five seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Initially, set the transmitter volume control to a middle setting.
Once audio is detected at the audio input, the transmit light will go on and the
transmitter will transmit the audio signal.
When audio is no longer detected, the transmitter will go into standby mode
after approximately one minute. The transmit light will go out. During standby
mode, no signal is transmitted.
5.8 GHz Digital Audio Transmitter
R
T
R
A
NSMI
T
Transmit light
User and Installation Guide
Page 6
R
Transmitter volume control
L
R
DC 9V
L R